WATEX WRO2000 reverse osmosis system 2000 lph

WATEX WRO2000 reverse osmosis system

Advantages: compact, high quality, competitive price

Reverse osmosis system for brackish water with permeate flow rate 2000 liters/hour.

WATEX WRO series reverse osmosis systems are used for low mineralised water (up to 4000 ppm) with different flow rates and installation possibilities (wall or ground mount). Reverse osmosis valves purify water from 99.2% of salts, pyrogenic substances and microorganisms.

Permeate quality and flow rate depends on intake water salt concentration, temperature, applied pressure, membrane selection and pretreatment.

Quality and operation control system:

• On-line conductivity meter 0-500 microS/cm
• Inlet water low pressure switcH
• Permeate High pressure switch
• Pressure indicators (inlet, after pump, concentrate)
• Permeate flow meter
• Concentrate drain flow regulation
• Pump pressure regulation valve
• Water leakage alarm and shut-off
• High conductivity alarm
• Automatic/manual flushing system
• Recirculation/recovery regulation

Notes:

• Data based on following parameters: 1500 mg/l NaCl solution at 10 bars, 5-9^oC, Salt rejection 99.2%, SDI<3 brackish and low-mineralized water
• Pretreatment required: mechanical filtration, iron removal, softening or antiscalant dosing, adsorption by activated carbon if chlorine presence)
• Clean water reservoir minimum 1000 liters required after reverse osmosis

OPTIONAL FEATURES:

• CIP station and tank for chemical cleaning of membranes
• Dosing station for chemical pretreatment
• PLC operating controller and SCADA vizualization
• High pressure switch
• Electromagnetic flow meters
• Temperature switch
• Stainless steel pipes and fittings (AISI304, AISI316)
• Pretreatment built-in
• Dry-run protection of the reverse osmosis pump.